Configuring the Communication Mode ManuallyThis topic gives instructions for configuring the communication mode manually.1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2. Press the OK button.The Set./Adj. Menu is displayed.3. Press ▲ or ▼ to select Interface Setup, and then press the OK button.4. Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.5. Press ▲ or ▼ to select Auto Detect, and then press the OK button.6. Press ▲ or ▼ to select Off, and then press the OK button.The display reverts to the Ethernet Driver menu.7. Press ▲ or ▼ to select Comm.Mode, and then press the OK button.8. Press ▲ or ▼ to select the communication mode, and then press the OK button.The display reverts to the Ethernet Driver menu.9. Press ▲ or ▼ to select Ethernet Type, and then press the OK button.10. Press ▲ or ▼ to select the Ethernet type, and then press the OK button.The display reverts to the Ethernet Driver menu.11. Press ▲ or ▼ to select Spanning Tree, and then press the OK button.12. Press ▲ or ▼ to enable or disable spanning tree support, and then press the OK button.The display reverts to the Ethernet Driver menu.Network Setting > Network Setting >Configuring the Communication Mode Manually iPF830010960Downloaded from ManualsPrinter.com Manuals
