Casio CTK-900 User Manual

Also see for CTK-900: Midi implementation Service manual

Contents

Casio CTK-900 User Manual Manual pdf 40 page image

Mixer FunctionE-381. While Channel 16 is selected, press the [ ]CURSOR button.• This selects the DSP channel.• Pressing the [ ] CURSOR button while the DSPchannel is selected returns to Channel 16.The following are the parameters whose settings can bechanged in the Parameter Edit Mode.z Tone (Range: 000 to 903, Drawbar organ tones 000 to 199)This parameter controls the tones assigned to each part.Anytime the tone is on the display, you can use the TONEbutton or DRAWBAR ORGAN button and then select adifferent tone, if you want.z Part On/Off (Settings: on, oFF)This parameter can be used to turn each part on (sounds) andoff (does not sound). The current on/off status of each part isindicated on the display as described below.z Volume (Range: 000 to 127)This is the parameter that controls the volume of the selectedchannel.z Pan Pot (Range: –64 to 00 to +63)This parameter controls the pan pot, which is the center pointof the left and right stereo channels. Setting “00” specifiescenter, a value less than “00” moves the point left, and a valuegreater than “00” moves it right.z Octave Shift (Range: –2 to 0 to +2)You can use octave shift to shift the range of the tone up ordown. When using the piccolo tone, there may be cases whenvery high notes you want to play are not included within therange of the keyboard. When this happens, you can useoctave shift to shift the keyboard range one octave up.You can use these parameters to tune each of the partsindividually.z Coarse Tune (Range: –24 to 00 to +24)This parameter controls the coarse tuning of the selectedchannel’s pitch in semitone units.z Fine Tune (Range: –99 to 00 to +99)This parameter controls the fine tuning of the selectedchannel’s pitch in cent units.The Mixer lets you control the effects applied to eachindividual part, making it different from the Effect Mode,whose settings are applied to all parts in general.z Reverb Send (Range: 000 to 127)This parameter controls how much reverb is applied to a part.A setting of “000” turns reverb off, while a setting of 127applies maximum reverb.• “Reverb Send” does not work with some drum sounds.Editing DSP Channel ParametersHow Parameters WorkTone ParametersS G P n or.tC n e lnahV u emloP na–2 :Range shifted two octaves down.–1 :Range shifted one octave down.0 :No shift+1 :Range shifted one octave up.+2 :Range shifted two octaves up.Tuning ParametersEffect ParametersO S i f thtcC u enT.F e u n eTniR e n dSbv707A-E-040A