E-24Using the Drawbar Organ Mode738A-E-026ATo select a drawbar organ tone1 Find the drawbar organ tone you want to use inthe tone list and note its tone number.2 Press the DRAWBAR ORGAN button.• This causes the drawbar organ tone selection screento appear.3 Use the number buttons to input the three digit tonenumber for the tone you want to select.NOTE• Always input all three digits for the tone number,including leading zeros (if any).• You can also increment the displayed tone number bypressing [+] and decrement it by pressing [–].To edit a drawbar organ tone1 Select the drawbar organ tone (000 to 049, 100 to199) you want to edit.2 Use the [] and [] CURSOR buttons to displaythe drawbar organ tone editing screen. Select theparameter whose setting you want to change.Example: Selecting the “Ft16’” parameter• There are a total of 13 parameters. You can use the[] and [] CURSOR buttons to cycle through them.See “Parameter Details” on page E-25 for moreinformation.• While the “More?” screen is on the display, you canadvance to the synthesizer and DSP effect editingscreens by pressing the [] CURSOR button or the[+] button.3 Use the [] and [] CURSOR buttons or the [+]and [–] buttons to change the setting of the currentlydisplayed parameter.• You can also change a parameter setting by enteringa value with the number buttons.• You can monitor the changes in a tone by playingnotes on the keyboard as you adjust parametersettings.NOTE• Selecting a different tone after you edit parametersreplaces parameter settings with those of the newlyselected tone.• If you have drawbar organ tones assigned to more thanone channel, changing the drawbar organ setting for oneof the channels causes the same setting to be appliedto all of the other channels as well.• See “To save an edited drawbar organ tone” on pageE-26 for information about saving your edits.F t 1 6 ’Parameter Setting Parameter NameDRAWBAR ORGANNumber buttons[+]/[–]CURSORD r a w b a r 1Tone Number Tone Name