Casio WK-3200 User Manual

Also see for WK-3200: Midi implementation User guide

Contents

Casio WK-3200 User Manual Manual pdf 84 page image

E-82Saving DataYou can save data you create and data you transfer to the keyboard from a computer to the keyboard’s built-in Flash memory, orto a SmartMedia card TM or floppy diskette (WK-3700). In this manual, SmartMedia cards and floppy diskettes are referred to as“external storage media”.The types of files that can be saved to external storage media are listed below. Note that each type of file can be saved to a specific,pre-defined user area, as shown in the “Savable File Types” table below.After you load SMF data from external storage media and store it in a user area, you can play it back using the SMF Player Mode.See “Using the SMF Player” on page E-74 for more information.Savable File Types*1: Package FileA package file combines tone settings, DSP effect settings, and other setup data into a single file that you can manage and load as a unit(package). Once you create a package file, you will be able to change the entire setup of the keyboard by loading a single package file.To create a package file, you need to download special package file software from the CASIO Music Site (http://music.casio.com/)and install it on your computer. For details about the package file software, see the information provided at the CASIO Music Site .*2: All of the user data (SMF to package file) in the above table can be handled as a single file. Note, however, that due to the sizeof the file, it cannot be stored on a floppy diskette.Package File Data ContentsData TypeSMFRhythm PatternsRegistrationsDrum Sound With WavesDrawbar Organ TonesTonesTones With WavesDSPUser Area190 to 199 (10 Songs)168 to 175 (8 rhythms)7 to 8 (2 banks)903 (1 set)190 to 199 (10 tones)790 to 799 (10 tones)810 to 819 (10 tones)190 to 199 (10 effects)738A-E-084AIMPORTANT!• Loading a package file loads the setting data listed in the table under “Package File Data Contents” into the user area, andreplaces all current data with the data in the package file.• When loading a package file or All Data from or writing such data to a SmartMedia card or floppy diskette (WK-3700 only),the display’s level meter shows the progress of the load/write operation as shown below.[Start] [End]TypeSMFRhythm PatternRegistrationUser song created in the Song Memory ModeDrum sound with wavesDrawbar organ toneToneTone with wavesDSPPackage File*1All User Data*2DisplayIndicatorSmfPatternRegistSongDr waveDrawbarToneTn waveDspPackageAll DataSaved Data1 Tune1 Pattern1 Bank1 Tune1 Set1 Tone1 Tone1 Tone1 Type1 Pack1 SetUser MemoryCapacity200168541001002010011File NameExtensionMIDZ00Z01Z02Z03Z04Z05Z06Z07Z08Z09User AreaNumber000 – 199160 – 1751 – 80 – 4900 – 903100 – 199700 – 799800 – 819100 – 199——