Casio XW-P1 User Manual

Also see for XW-P1: Manual

Contents

Casio XW-P1 User Manual Manual pdf 43 page image

Sounding Arpeggio Phrases AutomaticallyE-41There are two arpeggio types: step type and variation type.• With a step type arpeggio, you can edit its steps and itsparameters. A step type arpeggio can contain up to 16steps. You can change the following values for each step.• With a variation type arpeggio, you can edit only itsparameters.1. Hold down bm ARPEGGIO until the arpeggiotype selection screen shown below appears onthe display.2. From among the preset or user arpeggio typesselect the arpeggio type you want to edit.• To select an arpeggio type, perform the same operationas steps 3 through 6 for selecting a tone (page E-20).3. Press 7 EDIT.4. Use the bq up (q) and down (w) buttons tomove the item selection cursor (0) to “StepEdit”, and then press bq ENTER.• The “Step Edit” option will not be displayed if youselected a variation type arpeggio in step 2 above.5. Use the bo dial or the bq minus (–) and plus (+)buttons to change the TYPE, NOTE, and VELOsettings.• You can also use the 4 1 to 16 buttons to toggleeach step on or off.• While TYPE is selected, use the bq minus (–) andplus (+) buttons to turn the TYPE setting on or off.• You can use 5 (eight sliders excluding “MASTER”) tochange the values of the applicable step directly. Whenusing the sliders, press 2 1-8/9-16 to toggle betweensteps 1 through 8 (button unlit) and steps 9 through 16(button lit). Note, however, that you will not be able touse the sliders when TYPE is TIE and OFF.• You can specify the tie setting. For details how, see “Toconfigure tied note settings” on page E-52.• The table below shows the contents of the arpeggiostep editing menu.Editing an ArpeggioTYPE : Specifies the relative position in the arpeggiopattern where each of the keyboard notes will play.You can specify positions starting from the lowestnote played (L1) or from the highest note played(U1). You can even specify simultaneous play of upto five notes (P2 through P5).NOTE: Specifies a relative shift, in semitone steps, fromthe note played on the keyboard.VELO : Specifies the volume of the note.Step typeStep number