Casio XW-P1 User Manual

Also see for XW-P1: Manual

Contents

Casio XW-P1 User Manual Manual pdf 70 page image

Other Useful FunctionsE-683. Move a slider to adjust the setting of the part assigned to it.• Use the bq cursor (U, q, w, I) buttons to select a setting item.4. Use the 4 1 to 16 buttons to toggle parts 01 through 16 between on and off.• Each press of a button toggles it between lit (on) and unlit (off).• Holding a button down will turn that part on and turn all other parts off (solo mode). Press the same button again to exit thesolo mode.Example: To enter the solo mode for Part 08■ Part 01 through Part 16 Settings■ External Input Part Settings■ Master SettingsMixer SettingsDisplay Description SettingsPart Part on/off. Turns each part on or off. This is the same parameter that is turned on and off by the 41 to 16 buttons (page E-68). Off, OnTonePart tone. This is the tone of each part.While this item is selected, you can select a tone using the same operation as that used in the ToneMode.• A tone with DSP will have DSP next to the tone name on the display (page E-37).Part 01: Solo SynthP00 to Various U29Part 02 to 16: PianoP00 to Various U29Volume Part volume. This is the volume of each part. 0 to 127Pan Part panning. Adjusts the left-right position of sound in the stereo field. –64 to 0 to +63CoarseTune Part coarse tune. Shifts the pitch of notes by semitone units. –12 to 0 to +12FineTune Part fine tune. Shifts the pitch of notes by cent units. –99 to 0 to +99BendRange Part bend range. Specifies (in semitone units) the maximum change in pitch when the bs BENDERwheel is rotated. –24 to 0 to +24DSP Line Part DSP line. Specifies whether DSP (page E-37) is applied to the notes of each part. Off, OnRev Send Part reverb send. Controls how the reverb effect (page E-37) is applied to each part. 0 to 127Cho Send Part chorus send. Controls how the chorus effect (page E-37) is applied to each part. 0 to 127Display Description SettingsPartSame as “Part 01 through Part 16 Settings” (page E-68).VolumePanDSP LineRev SendCho SendN.Thresh Noise gate threshold. Reduces noise by cutting all input sound at a volume that is smaller than thissetting value. 0 to 127N.Release Noise gate release. Time that input sound is cut after its volume drops below the noise gate thresholdvalue. 0 to 127Auto Level Auto level control. Automatically adjusts the input signal level. The greater the setting value, the strongerthe effect. Off, 1 to 3Display Description SettingsVolume Master volume. Adjusts the volume of all the parts. 0 to 127Pan Master panning. Adjusts the left-right position of sound in the stereo field of all the parts. –64 to 0 to +634LitHold down for a short while.