ESIE05-03 Pre-Test Run ChecksPart 4 – Commissioning and Test Run 4–534511.3 Setting the Wireless Remote ControllerIntroduction To set the wireless remote controller, you have to set the address for:P The receiver of the wireless remote controllerP The wireless remote controller.Setting the addressfor the receiverThe address for the receiver of the wireless remote controller is factory set to 1. To change this setting,proceed as follows:Step Action1 Turn OFF the power.2 Remove the sealing pad on the top of the receiver.3 Set the wireless address switch (SS2) according to the table below. You can find the wire-less address switch attached on the PCB of the receiver and it is visible through the smallopening on the back of the receiver.4 If you use a wired and a wireless remote controller for one indoor unit, proceed as follows:1. Set the wired remote controller to MAIN: On the remote controller.2. Set the wireless remote controller to SUB: On the receiver with the MAIN/SUB switch(SS1).5 Seal off the opening of the address switch and the MAIN/SUB switch with the attachedsealing pad.6 Make sure to also change the address on the remote controller.1 2 3 MSS2SS1SSealing padSmall openingReceiver1 21 21 2333Unit No.SS2No. 3No. 2No. 1SMSMSS1MAIN SUBMAIN/SUB1 2 3 MSS2SS1SSealing padSmall openingReceiver
