MCO 305 Design Guide__ Parameter Reference __¾ default setting [ ] value for use in communication via serial communication port200 MG.33.L5.02 – VLT® is a registered Danfoss trademark MCO ParametersFor a better overview the MCO Parameters are divided into groups:32-** MCO Basic Settings32-0* Encoder 2 - Slave page 20132-3* Encoder 1 - Master page 20232-5* Feedback Source page 20932-6* PID controller page 21032-8* Velocity & Acceleration page 21333-** MCO Advanced Settings33-0* Home Motion page 21733-1* Synchronization page 21833-4* Limit Handling page 22933-5* I/O Configuration page 23133-8* Global Parameters page 23533-9* MCO Port Settings page 23734-** MCO Data Readouts page 23834-0* PCD Write Parameters page 23834-2* PCD Read Parameters page 23834-4* Inputs & Outputs page 23934-5* Process Data page 23934-7* Diagnosis Readouts page 240General Information on the Parameter ValuesSome limiting values are listed at 1 billion to make them more easily readable. However, the exact value is1,073,741,823. (= MLONG).Input RangeWhether the input range listed is exceeded is not checked by the program, since due to the large domainthere are no suitable test possibilities.NB!:Even within the areas indicated illogical inputs can result from the large differences in performanceof the motors and the wide variety of possible applications. Therefore, it is the responsibility of theprogrammer and the user to observe the performance ranges of the drive and of the system.NB!:If the value of the parameter is out of the range defined by the minimum and maximum value thecommand is not displayed and executed correct.