5.3.13 Control Cable LengthDigital in/digital outDependent on what electronics are being used, it is possible to calculate the maximum cable impedance based on the 4 kΩfrequency converter input impedance.Analog in/analog outAgain the electronics used puts a limitation on the cable length.5.3.14 Electrical Installation, Control Cables230 VAC50/60 Hz230 VAC50/60 HzTB6 ContactorTB5R112Brake Temp(NC)Anti-condensation heater (optional)(optional)91 (L1)92 (L2)93 (L3)PE88 (-)89 (+)50 (+10 V OUT)53 (A IN)54 (A IN)55 (COM A IN)0/4-20 mA12 (+24 V OUT)13 (+24 V OUT)18 (D IN)20 (COM D IN)15 mA 200 mA(U) 96(V) 97(W) 98(PE) 99(COM A OUT) 39(A OUT) 42 0/4-20 mA03+10 VDC0 VDC - 10 VDC0/4-20 mA24 VDC0201050406 240 VAC, 2A24 V (NPN)0 V (PNP)0 V (PNP)24 V (NPN)19 (D IN)24 V (NPN)0 V (PNP)27 24 V0 V(D IN/OUT)0 V (PNP)24 V (NPN)(D IN/OUT)0 V24 V2924 V (NPN)0 V (PNP)0 V (PNP)24 V (NPN)33 (D IN)32 (D IN)1 2ONA53 U-I (S201)ON21A54 U-I (S202) ON=0-20 mAOFF=0-10 V95400 VAC, 2AP 5-00(R+) 82(R-) 81+ - + -(P RS-485) 68(N RS-485) 69(COM RS-485) 610 V5 VS801RS-485RS-48521ONS801/Bus Term.OFF-ON3 PhasepowerinputLoad Share Switch ModePower SupplyMotorAnalog OutputInterfaceRelay1Relay2ON=TerminatedOFF=OpenBrakeresistor(NPN) = Sink(PNP) = Source= ==240 VAC, 2A400 VAC, 2A0 VDC - 10 VDC10 VDC37 (D IN) - option130BC548.12Illustration 5.51 Interconnect Diagram for D-framesHow to Install Design Guide96 Danfoss A/S © Rev. 06/2014 All rights reserved. MG20Z20255