Danfoss VLT AQUA Programming Manual

Also see for vlt aqua: Instructions Design guide Instruction manual Operating instructions Design guide

Contents

10-31 Store Data ValuesOption: Function:Parameter values changed via DeviceNet are not automaticallystored in non-volatile memory. Use this parameter to activate afunction that stores parameter values in the EEPROM non-vol-atile memory, so changed parameter values will be retained atpower-down.[0] * Off Deactivates the non-volatile storage function.[1] Store edit setup Stores all parameter values from the active set-up in the non-volatile memory. The selection returns to Off [0] when all valueshave been stored.[2] Store all setups store all parameter values for all set-ups in the non-volatilememory. The selection returns toOff [0] when all parametervalues have been stored.10-32 Devicenet RevisionRange: Function:0 * [0 - 65535] View the DeviceNet revision number. This parameter is used forEDS file creation.10-33 Store AlwaysOption: Function:[0] * Off Deactivates non-volatile storage of data.[1] On Stores parameter data received via DeviceNet in EEPROM non-volatile memory as default.10-39 Devicenet F ParametersArray [1000]No LCP access0 * [0 - 0] This parameter is used to configure the frequency converter viaDeviceNet and build the EDS-file.2.12. Main Menu - Smart Logic - Group 132.12.1. 13-** Prog. FeaturesSmart Logic Control (SLC) is essentially a sequence of user defined actions (see par. 13-52 [x])executed by the SLC when the associated user definedevent (see par. 13-51 [x]) is evaluated asTRUE by the SLC. Events andactions are each numbered and linked together in pairs. This meansthat whenevent [0] is fulfilled (attains the value TRUE),action [0] is executed. After this, theconditions ofevent [1] will be evaluated and if evaluated TRUE,action [1] will be executed andVLT ® AQUA Drive Programming Guide 2. Parameter DescriptionMG.20.O2.02 - VLT ® is a registered Danfoss trademark 1312