Danfoss VLT AQUA Programming Manual

Also see for vlt aqua: Instructions Design guide Instruction manual Operating instructions Design guide

Contents

[170] psi[171] lb/in 2[172] in WG[173] ft WGPower:[180] HP0-31 Custom Readout Min ValueRange: Function:0.00 * [0 - par. 32] This parameter allows the choice of the min. value of the customdefined readout (occurs at zero speed). It is only possible toselect a value different to 0 when selecting a linear unit inCus-tom Readout Unit, par. 0-30. For Quadratic and Cubic units theminimum value will be 0.0-32 Custom Readout Max ValueRange: Function:100.00 * [Par. 0-31 -999999.99 ]This parameter sets the max value to be shown when the speedof the motor has reached the set value forMotor Speed HighLimit, (par.4-13/4-14).0-37 Display Text 1Option: Function:In this parameter it is possible to write an individual text stringfor display in the LCP or to be read via serial communication. Ifto be displayed permanently select Display Text 1 in par. 0-20,0-21, 0-22, 0-23 or 0-24,Display Line XXX. Use the ▲ or ▼ but-tons on the LCP to change a character. Use the ◀ and ▶ buttonsto move the cursor. When a character is highlighted by the cur-sor, it can be changed. Use the ▲ or ▼ buttons on the LCP tochange a character. A character can be inserted by placing thecursor between two characters and pressing ▲ or ▼.0-38 Display Text 2Option: Function:In this parameter it is possible to write an individual text stringfor display in the LCP or to be read via serial communication. Ifto be displayed permanently select Display Text 2 in par. 0-20,0-21, 0-22, 0-23 or 0-24,Display Line XXX. Use the ▲ or ▼ but-tons on the LCP to change a character. Use the ◀ and ▶ buttonsto move the cursor. When a character is highlighted by the cur-sor, this character can be changed. A character can be insertedby placing the cursor between two characters and pressing ▲ or▼.2. Parameter Description VLT ® AQUA Drive Programming Guide38 MG.20.O2.02 - VLT ® is a registered Danfoss trademark2