Large jobs do not collateThese are possible solutions. Try one or more of the following:MAKE SURE C OLLATE IS SET TO ONFrom Print Properties or the printer control panel Finishing menu, set Collate to On.Note: Setting Collate to Off in the software overrides the setting in the Finishing menu.REDUCE THE COMPLEXITY OF THE PRINT JOBReduce the complexity of the print job by reducing the number and size of fonts, the number and complexity ofimages, and the number of pages in the job.MAKE SURE THE PRINTER HAS ENOUGH MEMORYAdd printer memory.Unexpected page breaks occurIncrease the Print Timeout value:1 From the printer control panel, press .2 Press the down arrow button until Settings appears, and then press .3 Press the down arrow button until General Settings appears, and then press .4 Press the down arrow button until Timeouts appears, and then press .5 Press the down arrow button until Print Timeout appears, and then press .6 Press the left or right arrow buttons until the value you want appears, and then press .Envelope seals when printingDue to humidity and heat, some envelopes become sealed during the printing process. If this happens, open therear door of the printer to allow envelopes to exit there.Solving option problemsOption does not operate correctly or quits after it is installedThese are possible solutions. Try one or more of the following:RESET THE PRINTERTurn the printer off, wait for about 10 seconds, and then turn the printer on.Troubleshooting140
