Diagnostic information 2-145Sensor (stapler pass through) static jam service checkSensor (output pass through) late jam service checkStep Check Yes No1 Check the media path for partially fed or jammed media.Is the media path free from partially fed or jammed media?Go to step 2. Remove any pre-staged or jammedmedia.2 Check the sensor (stapler pass through) for properoperation.1. Enter the diagnostic mode2. Select Finisher sensor test3. Select Sensor test4. Select pass & media5. Observe the line item “passthru”Does the display on the operator panel, change every timethe sensing area of the above sensor is interrupted orblocked.Go to step 4. Go to step 3.3 Check the above sensor for proper connection.Is the above sensor connected properly?Replace the outputoption. Replace theconnection.Step Check Yes No1 Check the output option for proper installation.Is the above component properly installed?Go to step 2. Remove thenreinstall the outputoption2 Check for obstructions in the media path between the basemachine and the output option.Is the media path free from obstructions?Go to step 3. Removeobstructions.3 Check the sensor (output pass through) for properoperation.1. Enter the diagnostic mode2. Select Output bin tests3. Select Sensor test4. Select Output bin x5. Observe the line item “passthru”Does the display on the operator panel, change every timethe sensing area of the above sensor is interrupted orblocked.Go to step 5. Go to step 4.4 Check the above sensor for proper connection.Is the above sensor connected properly?Replace thesensor (outputpass through).Replace theconnection.5 Perform a print test using the output option.Does the error continue?Replace the outputoption. Problem solved.assembly sensor(pass through)removal” onGo to “4-binmailboxpage 4-232.
