Diagnostic aids 3-39The entire process is complete when the progress bar appears completely shaded and the percentageindicator shows 100%. After completion, the panel returns to Disk Encryption.Wipe DiskThis setting provides you with a tool for erasing the contents of a disk.Warning: Wipe Disk removes a disk's data in such a way that it cannot be recovered.To change this setting:1. Touch to select Wipe Disk from Configuration Menu.Note: If an advanced password has been established, you must enter this password in order to changethe setting. If no advanced password exists, you can establish one by using the keyboard that appears onthe LCD.2. Touch to select Wipe disk now.Contents will be lost. Continue? appears on the touchscreen.3. Touch Back to return to Configuration Menu.4. Touch Yes to continue, or touch No to exit.Font SharpeningThis setting allows a user to set a text point size below which the high frequency screens are used whenprinting font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequencyscreens. The values for this setting range from 0 to 150, and the default value is 24. This setting affectsPostScript, PCL, and XL.To change this setting:1. Touch to select Font Sharpening from the Configuration Menu.2. Touch to increase the value or to decrease the value.3. Touch Submit to save the change.Touch Back to cancel and return to the Configuration Menu.This function is not supported when the device generates output at 600 dpi resolution.Require StandbyThis setting determines if the Standby Mode is On or Off. The default is On.If Standby Mode is On, the printer begins functioning in Standby Mode when it remains idle for an amount oftime. The Standby Mode enables the printer:• To consume less energy than when operating in normal mode but not as little as when operating in PowerSaver• To return to the Ready state more quickly than when operating in Power SaverTo change this setting:1. Touch to select Require Standby from the Configuration Menu.2. Touch Submit to save the change.Touch Back to cancel and return to the Configuration Menu.
