254 | Layer 3 Routingw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Verifying the configurationVerify the configuration with these show commands, in Privileged Exec or User Exec modes:Use the show ip igmp-proxy command to display host interface status parameters. It displays operationalparameters only when IGMP Proxy is enabled, as shown in Figure 17-225Figure 17-224. Using the show ip igmp-proxy Command• show ip igmp-proxy groups command: Figure 17-226• show ip igmp-proxy interface command: Figure 17-227Other relevant show commands include:• show ip igmp-proxy interface {unit/slot/port | vlan 1-3965}• show ip igmp-proxy groups {unit/slot/port [detail] | 1-3965 [detail]}• show ip igmp-proxy groups detailFigure 17-225. Using the show ip igmp-proxy CommandFigure 17-226. Using the show ip igmp-proxy groups CommandForce10 #show ip igmp-proxyAdmin Mode..................................... EnableOperational Mode............................... DisableForce10-S50V#show ip igmp-proxyVLAN .......................................... 2Admin Mode..................................... EnableOperational Mode............................... EnableVersion........................................ 3Number of Multicast Groups..................... 0Unsolicited Report Interval.................... 1Querier IP Address on Proxy Interface.......... 0.0.0.0Older Version 1 Querier Timeout................ 0Older Version 2 Querier Timeout................ 0Proxy Start Frequency.......................... 3Force10-S50V#show ip igmp-proxy groupsVLAN .......................................... 2Group Address Last Reporter Up Time Member State Filter Mode Sources--------------- --------------- ------- ------------ ----------- -------
