36 | Getting Startedw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Displaying StatisticsPrivileged Exec mode commands to display statistics include:• Switch summary statistics:— show interface switchport• Interface summary statistics:— show interface unit/slot/port• Switch detailed statistics:— show interface ethernet switchport• Interface detailed statistics:— show interface ethernet unit/slot/portUser ManagementThis section contains the following subsections:• Creating a User and Password on page 36• Showing and Removing Created Users on page 37• Setting the Enable Password on page 38• Enabling Ports on page 38• Setting the Management IP Address on page 39The default CLI user, admin, has read/write access, with no password until you create one (see Creating aUser and Password on page 36). The only way to recover from a lost admin password is to reload theswitch using factory defaults. See Restoring the System to the Factory Default Configuration on page 58.You can also control user access through access control servers, such as TACACS+ and RADIUS and withSSH. See Chapter 9, “Providing User Access Security,” on page 135 for details. The local users you create(up to six, including admin) all have read/write access.There is one mode-level password — commonly called the “enable” password — that you can configure toallow the user to move from User Exec mode to Privileged Exec mode in the CLI. See Setting the EnablePassword on page 38.Creating a User and PasswordThe username passwd command creates the username and password in one statement. You can change apassword either by reentering the command with the new password or by removing the user with the nousername command and reentering the user with a new password.
