Layer 3 Routing | 267Figure 17-249. Output of the show ip ospf interface vlan CommandVLAN Routing RIP ConfigurationThe two versions of the Routing Information Protocol (RIP) are described in RIP Configuration onpage 255. The following example demonstrates how to add support for RIPv2 to the configuration createdin the previous base VLAN routing example (Example of creating a routed VLAN between switches onpage 263). A second router, using port routing rather than VLAN routing, has been added to the network.Figure 17-250. RIP for VLAN Routing Example Network DiagramForce10 #show ip ospf interface vlan 10IP Address..................................... 10.1.1.1Subnet Mask.................................... 255.255.255.0OSPF Admin Mode................................ EnableOSPF Area ID................................... 0.0.0.2Router Priority................................ 1Retransmit Interval............................ 5Hello Interval................................. 10Dead Interval.................................. 40LSA Ack Interval............................... 1Iftransit Delay Interval....................... 1Authentication Type............................ MD5Authentication Key............................. "force10"Authentication Key ID.......................... 10Metric Cost.................................... 1 (computed)OSPF Mtu-ignore................................ DisableOSPF Interface Type............................ broadcastState.......................................... backup-designated-routerDesignated Router.............................. 2.2.2.2Backup Designated Router....................... 1.1.1.1Number of Link Events.......................... 3Force10 #
