90 | Stacking S-Series Switchesw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Figure 5-57. Using the member Command to Add a Unit to a StackRemoving a Switch from a StackUse the following procedure to remove a member switch from a stack (If you are removing themanagement unit, first use the movemanagement command, as described above):Step Command Syntax Command Mode Purpose1 interface range ethernetrangeGlobal Config Access the range of interfaces on the switch to beremoved from the stack. The command accesses theEthernet Range prompt within the Interface Rangemode. For example, for Unit 2, enter:interface range ethernet 2/0/1-2/0/502 shutdown Interface Range Disable all ports in the specified range.Alternatively, you could pull all of the portconnections from the switch.3 Remove the stacking cables from the unit to beremoved from the stack.4 stack Global Config Access Stacking Config mode.5 no member unit Stacking Config Remove the unit number from the logical stack so thatit can be recycled when you add another switch to thestack (or you renumber an existing stack member). SeeFigure 5-58 on page 91.Force10 #show supported switchtypeMgmt CodeSID Switch Model ID Pref Type--- -------------------------------- ------------ ---------1 SA-01-GE-48T 1 0x100b0003 SA-01-GE-48T 1 0x100b0004 SA-01-GE-48T 1 0x100b000Force10 #configureForce10 (Config)#stackForce10 (config-stack)#member 5 1Force10 (config-stack)#exitForce10 (Config)#exitForce10 #show switchManagement Preconfig Plugged-in Switch CodeSwitch Status Model ID Model ID Status Version------ ------------ ------------- ------------- --------------------- --------1 Mgmt Switch SA-01-GE-48T SA-01-GE-48T OK 2.3.1.53 Stack Member SA-01-GE-48T SA-01-GE-48T OK 2.3.1.54 Stack Member SA-01-GE-48T SA-01-GE-48T OK 2.3.1.55 Unassigned SA-01-GE-48T Not Present 0.0.0Force10 #Unit 5 added
