Stacking S-Series Switches | 91To remove a switch from the stack, use the no member unit command:Figure 5-58. Using the no member Command to Remove a Switch from a StackIf you do not use the no member unit command after removing a switch, the unit number is “Unassigned”:Figure 5-59. The show switch report Showing “Unassigned” after Removing a Switch from aStackSetting Management Unit PreferencesTo change the management unit priority of a stack member, use the switch unit priority value command:6 Attach the stacking cables to support the newconfiguration (see Figure 5-54 on page 84).7 show stack-port counters Privileged Exec Inspect the stack traffic data to confirm that the stack issuccessfully reconfigured. See Figure 5-68 on page 99.Step Command Syntax Command Mode PurposeForce10 (config-stack)#no member 5Force10 (config-stack)#exitForce10 (Config)#exitForce10 #show switchManagement Preconfig Plugged-in Switch CodeSwitch Status Model ID Model ID Status Version------ ------------ ------------- ------------- --------------------- --------1 Mgmt Switch SA-01-GE-48T SA-01-GE-48T OK F32.3.1.53 Stack Member SA-01-GE-48T SA-01-GE-48T OK F2.3.1.54 Stack Member SA-01-GE-48T SA-01-GE-48T OK F32.3.1.5Force10 #Unit 5 removedForce10 #show switchManagement Preconfig Plugged-in Switch CodeSwitch Status Model ID Model ID Status Version------ ------------ ------------- ------------- --------------------- --------1 Mgmt Switch SA-01-GE-48T SA-01-GE-48T OK2.3.1.53 Stack Member SA-01-GE-48T SA-01-GE-48T OK 2.3.1.54 Stack Member SA-01-GE-48T SA-01-GE-48T OK 2.3.1.55 Unassigned SA-01-GE-48T Not Present 0.0.0.0Force10 #
