56 | Getting Startedw w w . d e l l . c o m | s u p p o r t . d e l l . c o m When converting from a Routing image to a Switching image, you must interrupt the reboot to revert theswitch to factory defaults, as shown in Figure 3-27:Figure 3-27. Restoring Factory Defaults when Converting from Routing to Switching ImageManaging the ConfigurationThis section contains the following major subsections, in this order:• Clearing the Running Configuration on page 57• Saving the Startup Configuration to the Network on page 57• Configuring from the Network on page 58• Restoring the System to the Factory Default Configuration on page 58• Resetting the Pre-configured System on page 59Force10 #reloadManagement switch has unsaved changes.Would you like to save them now? (y/n) yConfiguration Saved!Are you sure you want to reload the stack? (y/n) yReloading all switches.Force10 Boot Code...Version 01.00.26 06/03/2005Select an option. If no selection in 2 seconds then operational code will start.1 - Start operational code.2 - Start Boot Menu.Select (1, 2):2Boot Menu Version 01.00.27 11/18/2005Options available1 - Start operational code2 - Change baud rate3 - Retrieve event log using XMODEM (64KB).4 - Load new operational code using XMODEM5 - Display operational code vital product data6 - Update Boot Code7 - Delete operational code8 - Reset the system9 - Restore Configuration to factory defaults (delete config files)[Boot Menu] 9[Boot Menu][Boot Menu][Boot Menu] 8Select 2 and press Enter within 2 seconds to invoke the Boot Menu.Select 9 and press Enter.Select 8 and press Enter.
