Configuring Switch Information 329Defining Ports to Receive Multicast Service1 Open the Bridge Multicast Group page.2 Define the VLAN ID and the Bridge Multicast Address fields.3 Toggle a port to S to join the port to the selected Multicast group.4 Toggle a port to F to forbid adding specific Multicast addresses to a specific port.5 Click Apply Changes.The port is assigned to the Multicast group, and the device is updated.Assigning LAGs to Receive Multicast Service1 Open the Bridge Multicast Group page.2 Define the VLAN ID and the Bridge Multicast Address fields.3 Toggle the LAG to S to join the LAG to the selected Multicast group.4 Toggle the LAG to F to forbid adding specific Multicast addresses to a specific LAG.5 Click Apply Changes.The LAG is assigned to the Multicast group, and the device is updated.Managing Multicast Service Members Using CLI CommandsThe following table summarizes the equivalent CLI commands for managing Multicast servicemembers as displayed in the Bridge Multicast Group page.Table 7-91. Multicast Service Member CLI CommandsCLI Command Descriptionbridge multicast address {mac-multicast-address | ip-multicast-address}Registers MAC-layer Multicastaddresses to the bridge table, and addsstatic ports to the group.bridge multicast forbidden address{mac-multicast-address | ip-multicast-address}[add | remove] {ethernetinterface-list | port-channel port-channel-number-list}Forbids adding a specific Multicastaddress to specific ports. Use the noform of this command to return todefaultshow bridge multicast address-table[vlan vlan-id] [address {mac-multicast-address | ip-multicast-address}] [format ip | mac]Displays Multicast MAC address tableinformation.
