Configuring PowerConnect 3424/P and 3448/P 73To recover a lost password when entering the local terminal only:1 From the Startup menu, type [3] and press . The password is deleted.Enter your choice or press 'ESC' to exit:Current password will be ignored!NOTE: To ensure device security, reconfigure passwords for applicable management methods.Enter Diagnostic Mode - option[4]For Technical Support only.Set Terminal Baud-Rate - option[5]To set the terminal baud-rate, type [5] and press .Enter your choice or press 'ESC' to exit:Set new device baud-rate: 38,400Software Download Through TFTP ServerThis section contains instructions for downloading device software (system and boot images)through a TFTP server. The TFTP server must be configured before downloading the software.System Image DownloadThe device boots and runs when decompressing the system image from the flash memory areawhere a copy of the system image is stored. When a new image is downloaded, it is saved in theother area allocated for the other system image copy.On the next boot, the device will decompress and run from the currently active system imageunless chosen otherwise.To download a system image through the TFTP server:1 Ensure that an IP address is configured on one of the device ports and pings can be sent to aTFTP server.2 Make sure that the file to be downloaded is saved on the TFTP server (the arc file).3 Enter the show version command to verify which software version is currently running on thedevice. The following is an example of the information that appears:console# show versionSW version 1.0.0.30 (date 27-Jan-2005 time 13:42:41)Boot version 1.0.0.05 (date 27-Jan-2005 time 15:12:20)HW version
