36 BigIron RX Series Configuration Guide53-1002253-01Flash memory and PCMCIA flash card file management commands3This output displays that one switchover occurred.Flash memory and PCMCIA flash card file managementcommandsThe BigIron RX Series system supports file systems in the following locations:• The management module’s flash memory.• A PCMCIA flash card inserted in the management module’s slots 1 or 2.Table 32 outlines the root directory for each file system.This section describes commands that manage the files in flash memory and on the flash cards.You can use the file management commands to perform the following tasks:• Format a flash card.• Determine the current management focus.• Switch the management focus.• Display a directory of the files.• Display the contents of a file.• Display the hexadecimal output of a file.BigIron RX# show logSyslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)Buffer logging: level ACDMEINW, 24 messages loggedlevel code: A=alert C=critical D=debugging M=emergency E=errorI=informational N=notification W=warningStatic Log Buffer:Sep 28 11:31:25:A:Power Supply 1, 1st left, not installedSep 28 11:31:25:A:Power Supply 3, middle left, not installedSep 28 11:31:25:A:Power Supply 4, middle right, failedSep 28 11:31:25:A:Power Supply 5, 2nd right, not installedDynamic Log Buffer (50 lines):Sep 27 18:06:58:I:Interface ethernet6/2, state upSep 27 18:06:57:I:Interface ethernet3/2, state upSep 27 15:39:42:I:Interface ethernet3/2, state upSep 27 15:39:42:I:Interface ethernet6/2, state up...Sep 27 14:23:45:N:Module up in slot 6Sep 27 14:23:45:N:Module up in slot 3Sep 27 14:23:27:A:Management module at slot 9 state changed from standbyto activeTABLE 32 BigIron RX file system root directoriesFile system Root directoryFlash memory /flash/PCMCIA flash card in slot 1 /slot1/PCMCIA flash card in slot 2 /slot2/
