1238 BigIron RX Series Configuration Guide53-1002253-01Displaying OSPFv3 information48This display shows the following information.Displaying OSPFv3 neighbor informationYou can display a summary of OSPFv3 neighbor information for the Brocade device or detailedinformation about a specified neighbor.To display a summary of OSPFv3 neighbor information for the device, enter the following commandat any CLI level.Syntax: show ipv6 ospf neighbor [router-id <ipv4-address>]The router-id <ipv4-address> parameter displays only the neighbor entries for the specified router.This display shows the following information.TABLE 216 OSPFv3 memory usage informationThis field... Displays...Total Static MemoryAllocatedA summary of the amount of static memory allocated, in bytes, to OSPFv3.Total Dynamic MemoryAllocatedA summary of the amount of dynamic memory allocated, in bytes, to OSPFv3.Memory Type The type of memory used by OSPFv3. (This information is for use by Brocade’stechnical support in case of a problem.)Size The size of a memory type.Allocated The amount of memory currently allocated to a memory type.Max-alloc The maximum amount of memory that was allocated to a memory type.Alloc-Fails The number of times an attempt to allocate memory to a memory type failed.TABLE 217 Summary of OSPFv3 neighbor informationField DescriptionRouter ID The IPv4 address of the neighbor. By default, the Brocade router ID is the IPv4 addressconfigured on the lowest numbered loopback interface. If the device does not have a loopbackinterface, the default router ID is the lowest numbered IPv4 address configured on the device.Pri The OSPFv3 priority of the neighbor. The priority is used during election of the DR and BDR.State The state between the Brocade device and the neighbor. The state can be one of the following:• Down• Attempt• Init• 2-Way• ExStart• Exchange• Loading• FullDR The router ID (IPv4 address) of the DR.BigIron RX# show ipv6 ospf neighborRouterID Pri State DR BDR Interface[State]1.1.1.1 1 Full 223.223.223.223 1.1.1.1 ethe 3/2 [DR]
