724 BigIron RX Series Configuration Guide53-1002253-01Displaying OSPF information25Displaying OSPF neighbor informationTo display OSPF neighbor information, enter the following command at any CLI level.To display OSPF neighbor information by area, enter a command such as the following.Syntax: show ip ospf neighbor [router-id ] | [] [area | ]The router-id parameter displays only the neighbor entries for the specified router.The parameter displays only the entry in the specified index position in the neighbor table.For example, if you enter “1”, only the first entry in the table is displayed.These displays show the following information.TABLE 114 CLI display of OSPF neighbor informationField DescriptionPort The port through which the device is connected to the neighbor.Address The IP address of this device’s interface with the neighbor.Pri The OSPF priority of the neighbor:• For multi-access networks, the priority is used during election of the Designated Router(DR) and Backup designated Router (BDR).• For point-to-point links, this field shows one of the following values:• 1 = point-to-point link• 3 = point-to-point link with assigned subnetBigIron RX# show ip ospf neighborPort Address Pri State Neigh Address Neigh ID Ev Op Cntv10 10.1.10.1 1 FULL/DR 10.1.10.2 10.65.12.1 5 2 0v11 10.1.11.1 1 FULL/DR 10.1.11.2 10.65.12.1 5 2 0v12 10.1.12.1 1 FULL/DR 10.1.12.2 10.65.12.1 5 2 0v13 10.1.13.1 1 FULL/DR 10.1.13.2 10.65.12.1 5 2 0v14 10.1.14.1 1 FULL/DR 10.1.14.2 10.65.12.1 5 2 0BigIron RX# show ip ospf neighbor area 1Port Address Pri State Neigh Address Neigh ID Ev Op Cntv10 10.1.10.1 1 FULL/DR 10.1.10.2 10.65.12.1 5 2 0
