Related Topics Performing Initial Software Configuration on the J-SRX210 Services Gateway UsingJ-Web Interface on page 96•• Connecting a J-SRX210 Services Gateway to the CLI Locally on page 85• J-SRX210 Services Gateway Software Configuration Overview on page 91• J-SRX210 Services Gateway Secure Web Access Overview on page 101Connecting a J-SRX210 Services Gateway to the CLI LocallyIf you plan to use the CLI to configure the J-SRX210 Services Gateway, you must connectthrough the console port, as shown in Figure 25 on page 85.Figure 25: Connecting to the Console Port on a J-SRX210 Services GatewayJ-SRX210NOTE: Figure 25 on page 85 shows a connection to a local management device. Aremote connection to the services gateway through a modem requires the cable andconnector shown (provided in the services gateway accessory box), plus a DB-9 femaleto DB-25 male (or similar) adapter for your modem, which you must purchase separately.To connect to the CLI using a local management device through the console port on theservices gateway:1. Turn off power to the services gateway.2. Turn off power to the management device, such as a PC or laptop computer, thatyou are using to access the CLI.3. Plug one end of the Ethernet cable supplied with your services gateway into theRJ-45 to DB-9 serial port adapter supplied with your services gateway (see Figure25 on page 85).85Chapter 15: Connecting the J-SRX210 Services Gateway to Management Devices
