Installing the J-SRX210 Services Gateway on a WallYou can install the J-SRX210 Services Gateway on a wall.NOTE: The wall-mounting kit is not shipped with the device and must be orderedseparately.To install the device on a wall:1. Place the device on a flat and level surface with the Dell Logo embossed on the topcover facing up. Ensure that rubber feet are attached to the bottom of the chassis.2. Position a mounting bracket on each side of the chassis as shown in Figure 20 onpage 72.Figure 20: J-SRX210 Services Gateway Wall Installation — AttachingMounting BracketsJ-SRXJ-SRX210210Table 31 on page 72 lists the parts used for installing the J-SRX210 Services Gatewayon the wall. The numbers in Figure 20 on page 72 correspond to the numbers in Table31 on page 72.Table 31: J-SRX210 Services Gateway Wall Installation PartsPartNumbersMounting brackets1Screws (Mounting bracket)23. Use a number-1 Phillips screwdriver to install the screws that secure the mountingbrackets to the chassis.4. If you are using wall anchors to support the chassis, install two pairs of anchors onthe wall, spaced apart equal to width of chassis with mounting brackets attached.5. Have one person grasp the sides of the device, lift it, and position it on the wall.72PowerConnect J-SRX210 Services Gateway Hardware Guide
