Table 19: Site Preparation Checklist for the J-SRX210 Services GatewayInstallation (continued)NotesDatePerformedByAdditional InformationItem or Task“Interface Cable and WireSpecifications for theJ-SRX210 ServicesGateway” on page 147• Acquire cables and connectors.• Review the maximum distanceallowed for each cable. Choosethe length of cable based on thedistance between the hardwarecomponents being connected.• Plan the cable routing andmanagement.Related Topics J-SRX210 Services Gateway Specifications on page 7•• General Site Guidelines for Installing the J-SRX210 Services Gateway on page 47• Installation Overview for the J-SRX210 Services Gateway on page 53• J-SRX210 Services Gateway Cabinet Requirements on page 48• J-SRX210 Services Gateway Rack Requirements on page 49• Clearance Requirements for Airflow and Hardware Maintenance of the J-SRX210Services Gateway on page 50General Site Guidelines for Installing the J-SRX210 Services GatewayThe following precautions help you plan an acceptable operating environment for yourJ-SRX210 Services Gateway and avoid environmentally caused equipment failures:• For the cooling system to function properly, the airflow around the chassis must beunrestricted. Allow sufficient clearance between the front and back of the chassis andadjacent equipment. Ensure that there is adequate circulation in the installation location.• Follow the ESD procedures to avoid damaging equipment. Static discharge can causecomponents to fail completely or intermittently over time.• Ensure that the blank Mini-PIM panel is installed in the empty slot to prevent anyinterruption or reduction in the flow of air across internal components.NOTE: Install the device only in restricted areas, such as dedicated equipment roomsand equipment closets, in accordance with Articles 110–16, 110–17, and 110–18 of theNational Electrical Code, ANSI/NFPA 70.Related Topics J-SRX210 Services Gateway Specifications on page 7•• J-SRX210 Services Gateway Safety Requirements, Warnings, and Guidelines on page 65• J-SRX210 Services Gateway Cabinet Requirements on page 4847Chapter 7: Preparing the Site for the J-SRX210 Services Gateway Installation
