Establishing Basic ConnectivityTo establish basic connectivity:1. Connect an Ethernet cable from any of the ge-0/0/1 or fe-0/0/2 to fe-0/0/7 portsto the Ethernet port on the management device (workstation or laptop).2. Connect the power cable to the device and a power source. (We recommend usinga surge protector.) Note the following indications:• Power LED (solid green): The device is receiving power.• Status LED (solid green): The device is operating normally.NOTE: The services gateway functions as a DHCP server and will assign an IP addressto the management device.3. Ensure that the management device acquires an IP address on the 192.168.1/24subnetwork (other than 192.168.1.1) from the device.NOTE: If an IP address is not assigned to the management device, manually configurean IP address in the 192.168.1/24 subnetwork. Do not assign the 192.168.1.1 IP addressto the management device, as this IP address is assigned to the device.4. Access the J-Web interface:a. Launch a Web browser from the management device.b. Enter 192.168.1.1 in the Address box.c. Specify the default user name as root. Do not enter any value in the Passwordbox.d. Press Enter. The J-Web Initial Setup page is displayed.5. Configure the basic settings such as Host Name, Domain Name, Root Password,and IP Address for your services gateway. Ensure that you have configured the IPaddress, root authentication, and default gateway before you apply the configuration.NOTE: All network and management access settings are optional.6. Click Apply to apply the configuration.NOTE: After configuring the basic settings, the Web session may timeout. Refresh orrelaunch the page if the applied configuration page is not displayed .97Chapter 16: Performing Initial Software Configuration on the J-SRX210 Services Gateway
