user@host > show chassis alarmsNo alarms currently activeFor more information, see the JUNOS Software Administration Guide.Related Topics Monitoring the J-SRX240 Services Gateway Components Using LEDs on page 89•• Monitoring the J-SRX240 Services Gateway Using Chassis Alarm Conditions on page 92• Monitoring the J-SRX240 Services Gateway Power System on page 93Monitoring the J-SRX240 Services Gateway Components Using LEDsThe LEDs available on the services gateway display the status of various components.Table 33 on page 89 describes the LEDs.Table 33: Component LEDs on the J-SRX240 Services GatewayPossible Causes and CorrectiveActionsMeaningStateLEDNormal condition. No action isrequired.The device is functioning normally.GreenStatus LEDNormal condition. No action isrequired.• The device is starting up.• The Reset Config button is pressed.AmberContact Dell Support. See “DellSupport” on page 96.An error is detected in the device.RedA major alarm indicates a criticalsituation on the gateway thatrequires immediate action. See A“Monitoring the J-SRX240 ServicesGateway Using Chassis AlarmConditions” on page 92.The device detects a major alarm.RedAlarm LEDA minor alarm requires monitoring ormaintenance. If left unchecked, itmight cause an interruption in serviceor degradation in performance. See“Monitoring the J-SRX240 ServicesGateway Using Chassis AlarmConditions” on page 92.Indicates a minor alarm.NOTE: The Alarm LED glows Amberwhile initializing.AmberNormal condition. No action isrequired.The device is starting up.NOTE: When the system is up andrunning, if the Alarm LED is off, itindicates that no alarms are presenton the device.Off89Chapter 16: Monitoring the J-SRX240 Services Gateway
