Connecting the J-SRX240 Services Gateway to the CLIIf you plan to use the CLI to configure the J-SRX240 Services Gateway, you must connectthrough the console port as shown in Figure 14 on page 66.Figure 14: Connecting a J-SRX240 Services Gateway to the CLINOTE: The above figure shows a connection to a local management device. A remoteconnection to the services gateway through a modem requires the cable and connectorshown (provided in the services gateway accessory box), plus a DB-9 female to DB-25male (or similar) adapter for your modem, which you must purchase separately.Connecting the Services Gateway to the CLI LocallyTo connect to the CLI using a local management device through the console port on theservices gateway:1. Turn off power to the services gateway.2. Turn off power to the management device, such as a PC or laptop computer, thatyou are using to access the CLI.3. Plug one end of the Ethernet cable supplied with your services gateway into theRJ-45 to DB-9 serial port adapter supplied with your services gateway.4. Plug the RJ-45 to DB-9 serial port adapter into the serial port on the managementdevice.66PowerConnect J-SRX240 Services Gateway Hardware Guide
