Card priority Card type Slot priority Max allowed40 Gb NICs (low profile) 3, 2, 1 35 FC16 HBA (full height) 4, 6, 5 3FC16 HBA (low profile) 2, 3, 1 36 10 Gb NICs (full height) 4, 6, 5 310 Gb NICs (low profile) 2, 3, 1 37 FC8 HBA (full height) 4, 6, 5 3FC8 HBA (low profile) 2, 3, 1 38 1 Gb NICs (full height) 4, 6, 5 31 Gb NICs (low profile) 2, 3, 1 39 12 Gb SAS (low profile) 3, 2, 1 212 Gb SAS (full height) 6, 4, 5 210 Integrated RAID integrated slot 111 NDC integrated slot 1NOTE: Ensure that the 100 G OPA x16 card is installed in slot 6 (x16 PCIe) on the alternate riser 3.Removing an expansion card from expansion card riser 2 or 3PrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.3. When removing a card from riser 3, ensure that the PCIe holder latch is closed.Steps1. Disconnect any cables connected to the expansion card.2. Lift the expansion card latch out of the guide slot.3. Hold the expansion card by its edges, and remove it from the expansion card connector.4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slotopening and close the expansion card latch.NOTE: You must install a filler bracket over an empty expansion card slot to maintain FederalCommunications Commission (FCC) certification of the system. The brackets also keep dustand dirt out of the system and aid in proper cooling and airflow inside the system.5. Install the expansion card latch into the slot.6. Close the expansion card locking tabs.129
