2. Replace the cooling shroud.3. Install the hard drives in their original locations.4. Follow the procedure listed in the After working inside your system section.Related LinksSafety instructionsBefore working inside your systemInstalling a hot-swap hard driveInstalling the cooling fan assemblyInstalling the cooling shroudAfter working inside your systemRemoving the optional hard drive backplane (rear)Prerequisites1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.3. Remove both hard drives.CAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.CAUTION: To prevent damage to the drives and backplane, you must remove the hard drivesfrom the system before removing the backplane.CAUTION: You must note the number of each hard drive and temporarily label them beforeremoval so that you can replace them in the same locations.Steps1. Disconnect all the cables from the backplane.2. Lift the release pin and slide the backplane toward the front of the chassis.3. Lift the backplane to remove it from the chassis.204
