Denon AVR-1613 Owner's Manual

Also see for AVR-1613: Getting started Specifications Service manual Getting started

25Error messagesNOTE• An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform thenecessary measures. Then perform Audyssey® Setup again.• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speakerconnections and repeat the measurement process from the beginning.• Be sure to turn off the power before checking speaker connections.Examples Error details MeasuresAudyssey SetupCaution!Microphone or Speaker is nonePlease check the cable connectionand retry.MultEQRetry• The connected setup microphone is broken, or a device other than thesupplied setup microphone is connected.• Not all speakers could be detected.• A front speaker (left) was not properly detected.• Connect the included setup microphone to the SETUP MIC jack of this unit.• Check the speaker connections.Audyssey SetupCaution!Ambient noise is too high or level istoo lowMultEQRetry• There is too much noise in the room for accurate measurements to bemade.• Speaker or subwoofer sound is too low for accurate measurements to bemade.• Either turn off any device generating noise or move it away.• Perform again when the surroundings are quieter.• Check the speaker installation and the direction in which the speakers arefacing.• Adjust the subwoofer’s volume.Audyssey SetupSpeaker Not found Error...Front RMultEQRetryPlease check the cableconnection and retry.• The displayed speaker could not be detected.(The screen on the left indicates that the front right speaker cannot bedetected.)• Check the connections of the displayed speaker.Audyssey SetupSpeaker Phase Error...Front RMultEQRetry Phase Info. SkipPlease check the cableconnection and retry.• The displayed speaker is connected with the polarity reversed.(The screen on the left indicates that the polarity phases of the front rightspeakers are reversed.)• Check the polarity of the displayed speaker.• For some speakers, this error message may bedisplayed even if the speaker is properly connected.If you are sure the connection is correct, use o pto select “Skip”, then press ENTER.Set up speakers (Audyssey® Setup)