Denon AVR-1613 Owner's Manual

Also see for AVR-1613: Getting started Specifications Service manual Getting started

83Audio Delay Default settings are underlined.While viewing video, manually adjust the time to delay audio output.Setting details0ms – 200ms• This item can be set within the range of 0 to 100 ms when “Auto Lip Sync” (vpage 87) is set to“On” and when a TV compatible with Auto Lip Sync is connected.• Store “Audio Delay” for each input source.Volume Default settings are underlined.Set the volume setting.Setting items Setting detailsScaleSet how volume isdisplayed.0 – 98 : Display in the range 0.5 (Min) to 98.–79.5dB – 18.0dB : Display ---dB (Min), in the range –79.5 dB to 18.0 dB.The “Scale” setting is applied also to the “Limit” and “Power OnLevel” display method.LimitMake a setting formaximum volume.Off : Do not set a maximum volume.60 (–20dB) / 70 (–10dB) / 80 (0dB)Power On LevelDefine the volume settingthat is active when thepower is turned on.Last : Use the memorized setting from the last session.Mute : Always use the muting on condition when power is turned on.1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.Mute LevelSet the amount ofattenuation when mutingis on.Full : The sound is muted entirely.–40dB : The sound is attenuated by 40 dB down.–20dB : The sound is attenuated by 20 dB down.AudioSubwoofer Level Default settings are underlined.Sets the subwoofer on/off and its output level.Setting items Setting detailsSubwooferTurn subwoofer output onand off.On : The subwoofer is used.Off : The subwoofer is not used.NOTEThis can be set when the sound mode is “DIRECT” (vpage 64) andthe “Subwoofer Mode” (vpage 94) is “LFE+Main”.Subwoofer LevelSet the subwoofer outputlevel.–12dB – +12dB (0dB)RestorerCompressed audio formats such as MP3, WMA (Windows Media Audio) and MPEG-4 AAC reduce theamount of data by eliminating signal components that are hard for the human ear to hear. The “Restorer”function generates the signals eliminated upon compression, restoring the sound to conditions near thoseof the original sound before compression. It also corrects the sense of volume of the bass to obtain richersound with compressed audio signals.Setting items Setting detailsRestorerSet the mode for“Restorer”.Off : Do not use “Restorer”.Mode1 (High) : Optimized mode for compressed sources with very weakhighs (64 kbps and under).Mode2 (Middle) : Apply suitable bass and treble boost for all compressedsources (96 kbps and under).Mode3 (Low) : Optimized mode for compressed sources with normalhighs (96 kbps and over).• This item can be set with analog signals or PCM signal (Sample rate =44.1/48 kHz) is input.• “Restorer” settings are stored for each input source.• This item default setting for “NETWORK” and “iPod/USB” is “Mode3(Low)”. All others are set to “Off”.• This cannot be set when the sound mode is set to “DIRECT”.