Denon AVR-2312CI Owner's Manual

Also see for AVR-2312: Service manual Protocol guide Getting started

103SYSTEM SETUPSetting items Setting detailsSpeaker Config.(Continued)Surr.Back : Set the presence, size and number of surround back speakers.• Large : Use a large speaker that can adequately play back lowfrequencies.• Small : Use a small speaker that has inadequate playback capacity forlow frequencies.• None : Select when the surround back speakers are not connected.• 2spkrs : Use two surround back speakers.• 1spkr : Use only one surround back speaker. When you select thissetting, connect the surround back speaker to the left (L) channel.Even when the “Surr.Back“ setting is other than “None”, soundmay not be emitted from the surround back speaker, depending onthe playback source. In this case, make “Surround Parameters” –“Surround Back” setting other than “OFF” (vpage 96).NOTEWhen “Amp Assign” setting (vpage 102) is “NORMAL”, you canmake the “Surr.Back” setting.Front Height : Set the presence and size of the front height speakers.• Large : Use a large speaker that can adequately play back lowfrequencies.• Small : Use a small speaker that has inadequate playback capacity forlow frequencies.• None : Select when the front height speakers are not connected.NOTEWhen “Amp Assign” setting (vpage 102) is “F.Height”, you can makethe “Front Height” setting.Setting items Setting detailsBass SettingSet subwoofer and LFEsignal range playback.Subwoofer Mode : Select low range signals to be reproduced bysubwoofer.• LFE : The low range signal of the channel set to “Small” speaker size isadded to the LFE signal output from the subwoofer.• LFE+Main : The low range signal of all channels is added to the LFEsignal output from the subwoofer.• “Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer”(vpage 102) is set to “Yes”.• Play music or a movie source and select the mode offering the strongestbass.• Select “LFE+Main” if you want the bass signals to always be producedfrom the subwoofer.NOTEIf “Front” and “Center” for “Speaker Config.” are set to “Large”, and“Subwoofer Mode” is set to “LFE”, no sound may be output from thesubwoofers, depending on the input signal or selected surround mode.LPF for LFE : Set LFE signal playback range. Set this when you want tochange the playback frequency of the subwoofer.• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz