24Error messagesNOTE• An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessarymeasures, then perform Audyssey® Auto Setup over again.• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speakerconnections and repeat the measurement process from the beginning.• Be sure to turn off the power before checking speaker connections.Examples Error details MeasuresAUDYSSEY AUTO SETUPRETURNRetryNo microphone or speakerCancelCaution!• The connected setup microphone is broken, or a device other than thesupplied setup microphone is connected.• Not all speakers could be detected.• The front L speaker was not properly detected.• Connect the included setup microphone to the SETUP MIC jack of this unit.• Check the speaker connections.AUDYSSEY AUTO SETUPRETURNRetryAmbient noise is too highor level is too lowCancelCaution!• There is too much noise in the room for accurate measurements to bemade.• Speaker or subwoofer sound is too low for accurate measurements to bemade.• Either turn off any device generating noise or move it away.• Perform again when the surroundings are quieter.• Check the speaker installation and the direction in which the speakers arefacing.• Adjust the subwoofer’s volume.AUDYSSEY AUTO SETUP1 2 3 4 5 6RETURNRetryFront R NoneCancelCaution!• The displayed speaker could not be detected.(The screen on the left indicates that the front right speaker cannot bedetected.)• Check the connections of the displayed speaker.AUDYSSEY AUTO SETUP1 2 3 4 5 6RETURNRetrySkipFront R PhaseCancelCaution!• The displayed speaker is connected with the polarity reversed.(The screen on the left indicates that the polarity phases of the front rightspeakers are reversed.)• Check the polarity of the displayed speaker.• For some speakers, this error message may bedisplayed even if the speaker is properly connected.If you are sure the connection is correct, press uito select “Skip”, then press ENTER.Set up speakers (Audyssey® Auto Setup)