27n Using the “SOURCE SELECT” menuSwitch the remote control unit to the J (MAIN ZONE) mode whenperforming this operation (vpage 118 “Operating AV devices”).If the remote control unit is in K (ZONE2) mode, the “SOURCESELECT” menu will not be displayed when SOURCE SELECT ispressed.BDRecentPlayerVideoNetworkTunerSOURCE SELECTSourceThe currently selected inputsource is highlighted.qweq Input SourceThe name of the highlighted input source is displayed.w Recently used sourcesThe recently used input sources (up to five) are displayed.e Icons for the input sources in the different categories aredisplayed.q Press SOURCE SELECT.Display the “SOURCE SELECT” menu.w Use uio p to select the input source,then press ENTER.The input source is set and the sourceselection menu is turned off.• When using with an iPod connected directly to the USB port of thisunit, select “ (USB/iPod)” for the input source.• Input sources that are not going to be used can be set ahead of time.Make this setting at “Source Delete” (vpage 113).• To turn off the source selection menu without selecting an inputsource, press SOURCE SELECT again.• When SOURCE SELECT is pressed, the AMP-operation mode startsautomatically (vpage 118).Adjusting the master volumeUse M df to adjust the volume.n When the “Volume Display” setting(vpage 113) is “Relative”GAdjustable rangeH– – – –80.5dB – 18.0dBn When the “Volume Display” setting (vpage 113) is“Absolute”GAdjustable rangeH 0.0 – 99.0• The variable range differs according to the input signal and channellevel setting.You can also operate via the main unit. In this case, perform thefollowing operations.Turn MASTER VOLUME to adjust the volume.Turning off the sound temporarilyPress N.• The power indicator flashes green.• “MUTE” indicator on the display lights.• appears on a TV screen.• The sound is reduced to the level set at “Mute Level” (vpage 113).• To cancel, press N again. Muting can also be canceled by adjustingthe master volume.Important information