Denon AVR-2312CI Owner's Manual

Also see for AVR-2312: Service manual Protocol guide Getting started

23Set up speakers (Audyssey® Auto Setup)14 Select “Store” and then press ENTER.Save the measurement results.AUDYSSEY AUTO SETUP1 2 3 4 5 6STEP6 StoreNow storing...Please wait.20%AUDYSSEY AUTO SETUP1 2 3 4 5 6RETURNStoreSTEP6 StoreApply and store measurement resultEnter CancelPress “Store” to store calculation results.• Saving the results requires about 10 seconds.• If the measuring results are not to be saved, press RETURN B.A message “Cancel auto setup?” will be displayed. Press o thenselect “Yes”. All the measured Audyssey® Auto Setup data willbe erased.• During saving of measurements results, “Now storing...Pleasewait.” is displayed. When saving is completed, “Storing complete.Auto Setup is now finished.” is displayed.NOTEDuring saving of measurement results, be sure not to turn off thepower.15 Unplug the setup microphone from the unit’s SETUPMIC jack.16 Set Audyssey Dynamic Volume®.AUDYSSEY AUTO SETUP1 2 3 4 5 6NoYesFinishTurn Dynamic Volume off and exit Auto SetupExitStoring complete.Auto Setup is now finished.Please unplug microphone.Turn on Dynamic Volume?• This feature adjusts the output volume to the optimal level whileconstantly monitoring the level of the audio input to the unit.Optimal volume control is performed automatically without anyloss in the dynamism and clarity of the sound when, for example,the volume suddenly increases for commercials shown duringtelevision programs.n When turning Dynamic Volume® on• Use u to select “Yes”, and then press ENTER.The unit automatically enters “Evening” mode.n When turning Dynamic Volume® off• Use i to select “No”, and then press ENTER.NOTEAfter performing Audyssey® Auto Setup, do not change the speakerconnections or subwoofer volume. In event of a change, performAudyssey® Auto Setup again.STEP 6Store FinishSTEP 5Check12 Use ui to select the item youwant to check, and then pressENTER.AUDYSSEY AUTO SETUP1 2 3 4 5 6RETURNNext StoreCrossover Freq. CheckSpeaker Config. CheckDistance CheckChannel Level CheckSTEP5 CheckProceed to next (Store)Enter CancelCheck processing results.To proceed, press “Next”.• Subwoofers may measure a greater reported distance thanthe actual distance due to added electrical delay common insubwoofers.• If you want to check another item, press RETURN B.13 Use i to select “Next → Store” and then pressENTER.NOTE• If the result differs from the actual connection status, or if “Caution!”is displayed, see “Error messages” (vpage 24). Then carry outAudyssey® Auto Setup again.• If you change speaker positions or orientation, perform Audyssey®Auto Setup again to find the optimal equalizer settings.