160AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsError messagesAn error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an errormessage is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.Examples Error details MeasuresMicrophone or Speaker isNone• Setup and measurement microphone is notdetected.• Not all speakers could be detected.• Connect the included Setup and measurement microphone to theSETUP MIC jack of this unit.• Check the speaker connections.Ambient noise is too high orlevel is too low• There is too much noise in the room.• Speaker or subwoofer sound is too low.• Either turn off any device generating noise or move it away.• Perform again when the surroundings are quieter.• Check the speaker installation and the direction in which thespeakers are facing.• Adjust the subwoofer’s volume.Front R : None • The displayed speaker could not bedetected.• Check the connections of the displayed speaker.Front R : Phase • The displayed speaker is connected withthe polarity reversed.• Check the polarity of the displayed speaker.• For some speakers, this error message may be displayed even ifthe speaker is properly connected. If you are sure the connection iscorrect, use p to select “Skip Error”, then press ENTER.
