169AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsSettingsMake settings for wired LAN.• If you are using a broadband router (DHCP function), there is no needto make the settings at “IP Address” and “Proxy”, since the DHCPfunction is set to “On” in this unit’s default settings.• Only set “Settings” when connecting to a network without a DHCPfunction.DHCP-IP Address-Subnet MaskProxySaveCancel-Address-Port-Default Gateway-Primary DNS-Secondary DNSConfigure the network settings manuallyOff192.168.000.001255.255.255.000255.255.255.000000.000.000.000000.000.000.000Off000.000.000.00000000Network/Settings2 DHCPSelects how to connect to the network.On : Configure the network settings automatically from your router.Off : Configure the network settings manually.2 IP AddressSet the IP address within the ranges shown below.• The Network Audio function cannot be used if other IP addressesare set.CLASS A: 10.0.0.1 – 10.255.255.254CLASS B: 172.16.0.1 – 172.31.255.254CLASS C: 192.168.0.1 – 192.168.255.2542 Subnet MaskWhen connecting an xDSL modem or connector adapter directly to thisunit, input the subnet mask indicated in the documentation supplied byyour provider. Normally input 255.255.255.0.2 Default GatewayWhen connected to a gateway (router), input its IP address.2 Primary DNS, Secondary DNSIf there is only one DNS address indicated in the documentationsupplied by your provider, input it at “Primary DNS”. If two or moreDNS are provided by your provider, enter both “Primary DNS” and“Secondary DNS”.
