165AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsDistancesSet distance from listening position to speakers.Measure beforehand the distance from the listening position to eachspeaker.2 UnitSet the unit of distance.Feet (Default)Meters2 StepSet the minimum variable width of the distance.1ft (Default) / 0.1ft0.1m / 0.01m2 Set DefaultsThe “Distances” settings are returned to the default settings.2 Set the distance0.0ft – 60.0ft / 0.00m – 18.00m%• The speakers that can be selected differ depending on the “Amp Assign”(vpage 162) and “Speaker Config.” (vpage 163) settings.• Default settings :Front L / Front R / F. Height L / F. Height R / F. Wide L / F. Wide R / Center /Subwoofer : 12.0 ft (3.60 m)Surround L / Surround R / Surr. Back L / Surr. Back R : 10.0 ft (3.00 m)• Set the difference in the distance between the speakers to less than 20.0 ft(6.00 m).LevelsSet the volume of the test tone to be the same when it is output fromeach speaker.2 Test Tone StartOutput test tone. A test tone is output from the selected speaker.While listening to the test tone, adjust the volume output from theselected speaker.–12.0dB – +12.0dB (Default : 0.0dB)%• When “Levels” is adjusted, the adjusted values are set for all the soundmodes.• When headphones are connected to the PHONES connector on this unit, youcannot set “Levels”.2 Set DefaultsThe “Levels” settings are returned to the default settings.
