Denon DN-S3500 Operating Instructions Manual

Also see for DN-S3500: Service manual

Contents

2ENGLISHENGLISH2 INSTALLING THE PLATTER, THE SCRATCH DISC ANDTHE SLIPMAT / CONNECTIONS(2) CONNECTIONS1. Turn off the POWER switch.2. Connect the RCA pin cords between the DN-S3500 outputs and inputs of your mixer.3. If your mixer has Fader Start function such as our DENON Mixer, connect FADER jack to the mixer using 3.5mm stereo mini cord.POWER ON OFFDIGITAL OUTLRLINE OUTFADER IN OUTMEMOLLLLRLRLLINE1 FADERPGM 1 FADERLINEOUT(3) INSTALLATIONPlease set up DN-S3500 horizontally.(4) INSTALLING THE 7” (17cm) RECORD ADAPTORYour own 7” (17cm) vinyl record can be installed on this product by using the provided adaptor.This original design grants you the freedom to use your favorite vinyl record for that ultimate analog turntablefeel.*Make sure the record used is flat and not warped.• 7” (17cm) record adaptor accessoriesq Adaptor (2) ........................................................1w Screw (< head) ................................................3e Fixing Plate .......................................................1DN-X300(1) INSTALLING THE PLATTER, THE SCRATCH DISC and THE SLIPMAT• Accessories 1. Install the Platter on the taper boss of the motor.2. Install the Slip Mat on the Platter.3. Insert D hole of the Scratch Disc on the D shaft ofthe Motor.NOTE: The printed face is located on the Slip Matside.4. Insert the Adaptor according to the direction of thearrow.NOTE: Please note the direction of insertion.NOTE:Depending on the RECORD you choose, frictionwith the Slipmat may not be enough, which cancause an undesired drag sound.If so, use a different record that’s thicker orheavier.1. Set Adaptor (2) in the hole of 7” record.2. Fix Plate with 3 screws. (< head).3. Insert D hole of the Adaptor (2) on the D shaft of theMotor.4. Insert the Adaptor (1) on the Adaptor (2).q Aluminum Platter..............................................1w Scratch Disc......................................................1e Slip Mat ............................................................1r Adaptor (1) ........................................................2(One is for spare parts.)Scratch Disc(Groove sideDOWN)D shaftSlip MatPlatterTaper Boss(Motor Unit)Fig. 1 Scratch DiscAdaptor (1)Fig. 2Fig. 3Screw (< head)Fixing Plate7” (17 cm) recordAdaptor (2)Fig. 1Fig. 2 7” (17cm) DiscAdaptor (2)Adaptor (1)Slip MatAdaptor (1)CAUTIONS:• Do not touch the motor unit.• Do not turn on the power without Platter.NOTE:Please note the fall of Platter when you move DN-S3500 after Platter is set.