Part NumberIssueDatePage61599388801301/2018174 / 24901/2018 174 (249)16 TOOL CHECK: FREE ANGLE TESTThe “Tool check: Free angle” strategy gives the angle values measured by a transducer and check ifthe measured value is within the tolerance limits defined in the Pset.NOTE: The “Tool check: Free angle” strategy is available only for Delta 6D/7D with aminimum firmware version equal to 2.7xNOTE: Use only transducers that measure angle.The test result gives the angle value measured during the test.During the test, the angle value is displayed:The LEDs are activated as follows:OK (green) LED The angle is within the limits defined in the Pset.The angle status is marked as OK.Low (yellow) LED Angle value lower than the minimum value.High (red) LED Angle value upper than the maximum limit.The buzzer is activated as follows:Buzzer High tone when green led is activated; otherwise, lower tone.16.1 Test Setup for Free Angle TestBelow are the Pset parameters for the “Tool check: Free Angle” strategy: Max angle Target angle Min angle Min Cm (angle) Min Cmk (angle)See the chapter “Pset” for further details about the parameters.
