Eaton 93PM Installation And Operation Manual

Also see for 93PM IBC-L: User and installation guide Manual Installation and operation manual User and installation guide User and installation guide

Contents

UPS System Installation4-2 Eaton 93PM UPS (20–100 kW, 480V – 100 kW Frame) Installation and Operation Manual P-164000227—Rev 6 www.eaton.com/powerqualityFigure 4-1. Removing the Pallet Skids and Supports – Eaton 93PM UPSWARNINGDo not remove or loosen the cabinet mounting or cabinet support bolts until instructed.4. Loosen, but do not remove, the skid mounting bolts holding the pallet skids to the front and rear supports,and to the left and right side supports (see Figure 4-1).5. If a sidecar is attached to the UPS, loosen, but do not remove, the sidecar skid mounting bolts holding thesidecar pallet skids to the sidecar front and rear supports, and to the left and right supports (see Figure 4-1and Figure 4-2).WARNINGRISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to becomeunbalanced. To prevent tipping the cabinet, raise and lower the jacking bolts evenly.CAUTIONCABINET MAY TIP. Raise the UPS no more than 3 mm (1/8") above the floor (just enough to allowthe removal of the pallet skids).CabinetMounting Bolts(4 places front)(4 places rear)Pallet SkidSkid Mounting Bolts(4 places front)(4 places rear)Floor Protectors(2 places front)(2 places rear)Right SideCabinet SupportRear CabinetSupportJacking Bolts(2 places front)(2 places rear)Front CabinetSupportCabinetSupport Bolts(2 places ateach corner)Left SideCabinet Support