UPS System InstallationEaton 93PM UPS (20–100 kW, 480V – 100 kW Frame) Installation and Operation Manual P-164000227—Rev 6 www.eaton.com/powerquality 4-5Figure 4-3. Removing the Sidecar Rear Shipping Bracket – Eaton 93PM UPS4.3 Integrated Battery Cabinet InstallationIf installing Integrated Battery Cabinets (IBCs), refer to the Eaton 93PM Integrated Battery Cabinet InstallationManual – Large and Large High Rate, the Eaton 93PM Universal Integrated Battery Cabinet InstallationManual-Large and Large High Rate, the Eaton 93PM Integrated Battery Cabinet Installation Manual-Small, orthe Eaton 93PM Integrated Battery Cabinet-Small Welded IBC-SW (432V and 480V) Installation Manual, listedin paragraph 1.8, for installation instructions.After the IBC is installed, proceed to paragraph 4.4 if a Sidecar Integrated Accessory Cabinet-Bypass (SIAC-B)is attached to the UPS, or to paragraph 4.5 if a Sidecar Integrated Accessory Cabinet-Tie (SIAC-T) is attachedto the UPS, or to paragraph 4.6 if a Sidecar Integrated Accessory Cabinet-Tie Bypass (SIAC-TB) is attached tothe UPS, or to paragraph 4.7 if installing an Integrated Accessory Cabinet-Tie (IAC-T), or to paragraph 4.8 ifinstalling an Integrated Accessory Cabinet-Distribution (IAC-D); otherwise, proceed to paragraph 4.9 tocomplete the wiring of the UPS.4.4 Sidecar Integrated Accessory Cabinet-Bypass Wiring InstallationIf an SIAC-B is attached to the UPS, refer to the Eaton 93PM Sidecar Integrated Accessory Cabinet-BypassInstallation and Operation (50 kW and 100 kW SIAC-B) Manual, listed in paragraph 1.8, for wiring installationinstructions.After the SIAC-B is wired, proceed to paragraph 4.7 if installing an Integrated Accessory Cabinet-Tie (IAC-T), orto paragraph 4.8 if installing Integrated Accessory Cabinet-Distribution; otherwise, proceed to paragraph 4.9 tocomplete the wiring of the UPS.Rear Shipping Bracket
