Eaton HFX Series Installation And Operation Manual

EATON HFX Product Family Installation and Operation Manual E-ELCL-II002-E2 July 201910Input Type Frequency, Ch 3-8, Analog, Pull-up or Pull-down Resistor (Software Configurable)Analog Input Resolution 9 bitsAccuracy +/- 2% FSMeasuring Range 0…5VInput Type Variable reluctance (Software configurable)Maximum Input Frequency Ch 1-2 (FREQ) (0-5 V square or sine wave) 0Hz...25kHz* Note: maximum aggregate is 200 kHz. Note: phase and duty cycle are not supported bythese inputs minimum detectable pulse duration is 20 μsecSwitch-on Level Selectable as 2.2 V or self-adaptive (input device changes voltage with frequency)Switch-off Level Selectable as 0.0 V or 1.0 VInput Type Variable Reluctance, Ch 1-2, Analog (Software Configurable)Analog Input Resolution 9 bitsAccuracy +/- 15% FSMeasuring Range 0…5VOutput Type High Side (Software configurable)Max Amperage 2ADiagnostics Open/Short circuit protectionOutput Type Low/High side, H-Bridge (Software configurable)Max Amperage 4ADiagnostics Open/Short circuit protectionOutput Type PWMi, High side (Software configurable)Max Amperage 2ADiagnostics Open/Short Circuit ProtectionPWM Frequency 50 – 2 kHzDither Frequency Configurable 1 - 500 HzDither Amplitude Configurable 1 - 100%Control Range 0.05 - 2 AControl Resolution 1 mAFly Back Protection IntegratedDuty Cycle Resolution .01% @ 250 HzOutput Type PWMi, High Side (Software configurable)Max Amperage 4ADiagnostics Open/Short circuit protectionPWM Frequency 50 – 2 kHzDither Frequency Configurable 1 - 500 HzDither Amplitude Configurable 1 - 100%Control Range 0.05 - 4 AControl Resolution 1.5 mAFly Back Protection IntegratedDuty Cycle Resolution .01% @ 250HConnector Manufacturer Deutsch Inc.Model DRC23-40PA & DRC23-40PBContact Surface Nickel platedA and B Connector Assembly Parts List Mating connector: P/N: DRC26-40SA & DRC26-40SB, size 20 solid contacts P/N: 0462-201-20141intended for 20AWG wire, P/N: 0462-005-20141 intended for 16-18 AWG wire, size 20 stamped andformed contacts P/N: 1062-20-0122 (nickel plated), and sealing plug P/N: 0413-204-2005A and B Connector Tooling Manufacturer DeutschA and B Connector Hand Tool Part Number Solid contacts: Service crimper: HST-1561 Production crimper(ratcheting): HDT-48-00Stamped contacts: DTT-20-00A and B Connector Contact Removal Tool P/N: 0411-240-2005P Connector Assembly Parts List Mating connector DT06-6S-EP06, size 16 solid contacts P/N 0462-201-16141intended for 14-18AWG wire, size 16 stamped and formed contacts P/N 1062-16-0122(nickel plated),wedge W6S-P012, sealing plug P/N 0413-217-1605P Connector Tooling Manufacturer DeutschP Connector Hand Tool Part Number Solid contacts: Service crimper: HST-1561 Production crimper(ratcheting): HDT-48-00Stamped contacts: DTT-16-00HFX Product Family