Eaton HFX Series Installation And Operation Manual

EATON HFX Product Family Installation and Operation Manual E-ELCL-II002-E2 July 201992.0 TECHNICAL SPECIFICATIONSEaton HFX ControllersDimensions 212.61mm L x 134.17mm W x 58.55mm HWeight 43.2 ounces (1225 grams)Storage Temperature Range -40 - +125 °COperating Temperature Range -40 - +105°C (USB use is limited to 85°C)IP Rating IP67/IP69KOperating Altitude 0-4000 mSupply Voltage 6-32 VDC, Nominal operation @ 12 /24 VDCReverse Polarity Protection IntegratedPeak Supply Voltage 36 VDCMaximum Current 48 A @ 85°C (40 A @ 105°C)Idle Current 12/24 VDC 120 mAStandby Current 12/24 VDC <3.5mA@12V, <2.5mA@24VIgnition Pin (A16) Enable/Disable standby modeCPU Type Renesas Super H 72546Frequency 200 MHzBit Width 32 BitFPU Integrated on chipData Memory (RAM retain) (additional to cpu) 32 KbyteFlash (ROM program & data combined) 3.75 MbyteSRAM 256 KbyteEEPROM 128 KbyteCAN Specification 2.0A, 2.0BCAN Baud Rates 50 kb/s,100 kb/s,125 kb/s,250 kb/s,500 kb/s,800 kb/s,1Mb/sCAN Protocol CANOpen, SAE J1939CAN CCP Default Node Address 0CAN Default Baud Rate 250kb/sUSB Specification USB 2.0 (Note: 3.0 devices are compatible)USB Baud Rates See belowUSB Default Node Address N.A.USB Default Baud Rate 1.5 Mb/sNumber of Sensor Supplies 2Sensor Supply Output Voltage 5 VDC or 10 VDC (configurable)Sensor Supply Maximum Current 200 mA @ 5VDC, 100 mA @ 10V per supplyAnalog Input Resolution 12 bits, *10 bitsAccuracy +/- 1 % FSMeasuring Ranges 0...5 V, 0...10 V*, 0...32 V, 0...20 mAShort Circuit Protection IntegratedOpen Circuit Detection Dependent upon selectable terminationInput Sampling Frequency 1 kHzInput Type Digital Low/High Side (Software configurable)Maximum Input Frequency 200 HzSwitch-on Level Software configurableSwitch-off Level Software configurableInput Type Frequency, Digital Low/High side, (Software configurable)Maximum Input Frequency Ch 3-8 (FREQ) (0-5 V square wave) Ch 3-8 0 Hz...50 kHz* in Frequency mode. Note: maximum aggregate is 200 kHz,Minimum detectable pulse duration is 20 μsecMaximum Input Frequency Ch 3-8 (Dig)Switch-on Level (design review required) Standard switch on at 3.0 V (this can be changed in hardware)Switch-off Level (design review required) Standard switch off at 2.0 V (this can be changed in hardware)HFX Product Family