Eaton Menvier 20 Administrator's And User Manual

Contents

1. Introduction Menvier30/40/100/300Page 4Full Set, and includes all the detectors. There are three other securitylevels called Part Set B, C and D. For example, in a small shop Full Setmight monitor the whole premises, while Part Set B might monitor just thestore room. Any rear doors would normally be monitored 24 hours a day(see “24 Hour Alarms” below).WardsIf the system is installed at a site where some users must be restricted toparts of the site, for example a warehouse with storage areas and separateoffices, then the installer can split the system electronically into separate“wards”.The Menvier300 can have up to 20 wards, the Menvier100 up to 10, theMenvier40 up to five and the Menvier30 up to four. Users can set and unseteach ward completely independently of all the others. Individual users canbe given access to one or more wards: if they have no access to a wardthen they cannot set or unset that ward. In effect the system splits into 20(or 10, or five or four) separate alarm systems.In addition each ward can be programmed to set at one of two securitylevels: either Full Set or Part Set. Any user who is allowed to set a wardcan select either of the two security levels.24 Hour AlarmsThe control unit can also monitor detectors continuously rather than beingset and unset. For example:Fire and smoke detectors, flood sensors, Hold Up Alarm buttons oremergency exits.Monitors for machinery (for example freezers) or other type of“technical alarm”.These are collectively known as “24-hour alarms” because they can causean alarm 24 hours a day: it does not matter whether a user has set or unsetthe system.CommunicationsYour system may be fitted with a communication module that allows thecontrol unit to send alarm information over the telephone network, themobile phone network, or the internet. There are separate modules foreach of these different tasks.The Installer may also be able to call into your control unit and program itremotely. Depending on how your Installer has programmed the system