www.eaton.com IM02601004E Page 573 InstallationThe Red Event LED on the Display unit will turn on when an event is triggered. When the useracknowledges all the triggered output events from all the meters connected to the display, the RedEvent LED will turn off.NOTE: The Health and Event LEDs on the Display unit report on every meter connected to thedisplay.3.17. Display Link AddressingThe Power Xpert Base Meter has a rotary Base Address switch (meter address) located on thebottom left side of the meter. This rotary switch is used for addressing the display link and acts asboth the user input and a simple indicator. All other communication links, except the local con-figuration port which is locked at 192.168.1.1, will be configured in the setpoint section of the userinterface.This Base Address switch is for the Display Port (COM0) only and is not to be used for any othercommunication port (COM1, COM2 or COM3).3.18. Java JRE PC InstallationPrior to accessing the Power Xpert Meter from your PC, you must download the latest version ofJava J2SE JRE (Java Runtime Environment). To do this, follow the steps below.1) Visit site http://java.sun.com/.2) Click on Downloads from the left side of the screen.3) Select the latest version of J2SE from the drop down list under Java 2 Platform,Standard Edition (J2SE) and click on GO.4) Click on Download JRE from the list.5) Select the appropriate download based on your operating system.6) Download and install the Java JRE.3.19. Comm ResetYou can reset all of the communications ports by pressing a recessed button located to the left ofthe status LEDs. The button is marked “Com Reset.” This may be done as part of troubleshooting.The button must be held for at least 2 seconds to prevent pressing it accidentally.
